MIP's and HIDE on checkpoint NG

["Cariddi, Richard" <Richard_Cariddi () acml com>]

Would anyone know the order of operations for NAT on a CheckPoint box?
The dilemma is as follows:
There exists a MIP 192.168.1.1:206.218.1.1 -> 10.1.1.1
There also exists a Hide rule:
192.168.0.0->10.1.1.1 (*hide behind 206.218.10.1*)

Does the MIP take predecedance over the hide?
So basically if 192.168.1.1 initiates a session to 10.1.1.1, will it take
the 206.218.1.1 address and not the HIDE address of 206.218.10.1?


Any information is appreciated.
Thank you,

Richard J. Cariddi, CCNP
Network Routing/Switching/Firewalls
Office:212.887.2202 
Mobile:914.980.8395
Fax:212.887.3090
 
Alliance Capital Management
135 West 50th Street, 5th fl.
New York, NY 10020
 
-----------------------------------------
The information contained in this transmission may contain privileged and confidential information and is intended only 
for the use of the person(s) named above. If you are not the intended recipient, or an employee or agent responsible 
for delivering this message to the intended recipient, any review, dissemination, distribution or duplication of this 
communication is strictly prohibited. If you are not the intended recipient, please contact the sender immediately by 
reply e-mail and destroy all copies of the original message. Please note that we do not accept account orders and/or 
instructions by e-mail, and therefore will not be responsible for carrying out such orders and/or instructions.



---------------------------------------------------------------------------
----------------------------------------------------------------------------