Bugtraq mailing list archives
Re: Linksys WRT54G - Advice for european users
From: Richard Bjerregaard <bjerregaard () jyde dk>
Date: Wed, 9 Jun 2004 00:15:06 +0200
Hejsa Ethan 7. juni 2004, 18:56:18, you wrote: CEMW> Another bit of warning about linksys and their inability to get the firmware CEMW> release vs. hardware version worked out correctly. If you install the CEMW> latest WAP54G firmware update for the v2 hardware on v1 or v1.1 hardware CEMW> (which the readme says is supported)... Expect the ethernet port to disable CEMW> itself (due to the order in which the interfaces are initialized on the CEMW> device) after you power cycle it... From the readme.txt " Note: If you try and upgrade an older unit to firmware 2.07 without upgrading the firmware to 1.09.1 prior to upgrade, you may damage the Access Point." Checkout these links http://www.linksys.com/international/firmware.asp?intfwid=9&coid=48 This document explains how to upgrade your WAP54G to firmware version 2.07.01 The procedure applies to V1.0 and V1.1 hardwares. http://www.linksys.com/download/vertxt/WAP54GupgradeprocedureV2.doc -- Best regards/Venlig hilsen Richard Bjerregaard
Current thread:
- Linksys WRT54G - Advice for european users Christer Palm (Jun 07)
- <Possible follow-ups>
- RE: Linksys WRT54G - Advice for european users Connor, Ethan M. W (Jun 07)
- RE: Linksys WRT54G - Advice for european users micm (Jun 08)
- Re: Linksys WRT54G - Advice for european users Richard Bjerregaard (Jun 09)
- RE: Linksys WRT54G - Advice for european users Connor, Ethan M. W (Jun 14)