nanog mailing list archives
Re: Need help with Cisco VLAN bridging....
From: "Kent Yu" <yux () lucent com>
Date: Sat, 10 Feb 2001 15:37:59 -0500
Craig, Apart from other suggestions, I think you also can do this: 1)Put ip address at both ends of the DS3; 2) Esbalish tunnels for each of your vlan using different loopback interfaces; 3)put the vlans in their respective tunnles using brigde-group; 4) use rate limit based on the soure of loopback interface of the tunnel to control how much each tunnel(vlan) can use the DS3; Not sure wether you want to turn on the IRB, probably not. Of course this is preety urgly using layer 3 to solve layer2 problem, but just off the top of my head. HTH Kent Yu ----- Original Message ----- From: "Craig Holland" <cholland () yahoo-inc com> To: "Nanog@Merit. Edu" <nanog () merit edu> Sent: Friday, February 09, 2001 5:22 PM Subject: Need help with Cisco VLAN bridging....
Has anyone had experience bridging multiple VLANs accross a clear-channel DS3? I have 2 3640's populated with 1 FE and 1 HSSI. They are connected
by
a DS3. I've tried a couple of different configs, including turning one router into a frame swich and building a PVC for each VLAN, but the
bridging
didn't seem to work. I've tried running SDE directly between the HSSI ports...and that didn't seem to work. I'm up a against a deadline here,
and
would greatly appreciate any help you can offer. I've also tried a couple of IRB configs. Thanks in advance, craig Craig Holland Network Engineer Yahoo! Inc. (408)731-3572 Y!Messenger: cholland
Current thread:
- Need help with Cisco VLAN bridging.... Craig Holland (Feb 24)
- Re: Need help with Cisco VLAN bridging.... Ryan O'Connell (Feb 24)
- Re: Need help with Cisco VLAN bridging.... Yonkerbonk (Feb 24)
- Re: Need help with Cisco VLAN bridging.... Kent Yu (Feb 24)
- <Possible follow-ups>
- RE: Need help with Cisco VLAN bridging.... Craig Holland (Feb 24)