nanog mailing list archives
Re: How to pick a Site-Local Scope multi cast address
From: Marshall Eubanks <tme () multicasttech com>
Date: Sat, 9 Dec 2006 15:38:46 -0500
Hello;I think that pretty much everything John Kristoff said was spot on, especially to thank you for asking.
Unfortunately, there is no general method for doing this except to use your GLOP address, if you have one, and that is not really appropriate for site-local work. Madcap and MZAP were implemented into Windows, but I have never heard of them being used.
If you look at http://www.iana.org/assignments/multicast-addresses it says that239.255.000.000-239.255.255.255 Site-Local Scope [Meyer,RFC2365] should be used for site local scope, but I know that that is not really followed much either.
So, my advice is - pick something at random from 239.255/16 - let us know what it is- give the user a config file or some other means to change it if they have too.
I would be glad to collect and maintain a list of site-local multicast addresses, but I have no illusions that
such a list would be complete. It would be worth doing, however.If you really feel that this is something where there will be millions deployed, contact me offlist and we
can discuss getting an address from IANA. Hope this helped, and, again, thank you for asking. Regards Marshall Eubanks On Dec 8, 2006, at 10:54 AM, Dave Raskin wrote:
Hello, I have been directed to this list by IANA when I asked the following question: I am researching ways of device/machine discovery on the network. Thisis similar to the Discovery phase of UPnP devices, which uses the SSDPprotocol. I have researched far enough to know that my best bet for UDP multicast address group is the Site-Local Scope address range of 239.255.000.000-239.255.255.255 SSDP and UPnP protocols use the address 239.255.255.250 My question is this: How do I pick a group address within this range and not have a chance of colliding with some other application on the network already using the group address I just picked? Do I just randomly pick an address in that range and hope for the best? I am running on Windows and cannot assume that there is a MADCAP server available. Thanks in advance! Dave Raskin Rimage Corporation
Current thread:
- How to pick a Site-Local Scope multi cast address Dave Raskin (Dec 08)
- Re: How to pick a Site-Local Scope multi cast address John Kristoff (Dec 08)
- Re: How to pick a Site-Local Scope multi cast address Marshall Eubanks (Dec 09)