nanog mailing list archives
Catalyst 6500 High Switch Proc
From: "Philip L." <phil () mindfury net>
Date: Sat, 15 Nov 2008 16:35:28 -0500
Hello.I've run into a bit of a snag and I hope some folks here may be able to enlighten. From time to time I check the 'sh platform hardware capacity' command on our Catalyst 6509s and have noticed this item:
CPU ResourcesCPU utilization: Module 5 seconds 1 minute 5 minutes 5 RP 1% / 0% 3% 4% 5 SP 82% / 27% 62% 73%
This is shown on two 6509 switches that we operate as Core layer devices. This value goes up to 85-90% during periods of peak traffic and I'm concerned that this may be a problem.
Checking 'sh proc cpu' is usually 10% or less.I've gone over this document backwards and forwards and none of the situations outlined seem to apply here:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a00804916e0.shtmlOne thing to note, is that our main ACL for ingress traffic is applied here due to historical reasons. It's roughly 5000 single host entries at present. We also use these devices for NDE.
I'm probably missing some other key details, but what could influence the SP like this? Any insight would be appreciated.
-- Philip L.
Current thread:
- Catalyst 6500 High Switch Proc Philip L. (Nov 15)
- Re: Catalyst 6500 High Switch Proc Jon Lewis (Nov 15)
- Re: Catalyst 6500 High Switch Proc Florian Weimer (Nov 15)
- Re: Catalyst 6500 High Switch Proc Philip L. (Nov 15)
- Re: Catalyst 6500 High Switch Proc Jon Lewis (Nov 15)
- Re: Catalyst 6500 High Switch Proc Kevin Loch (Nov 15)
- Re: Catalyst 6500 High Switch Proc Jon Lewis (Nov 15)
- Re: Catalyst 6500 High Switch Proc Ross Vandegrift (Nov 17)
- Re: Catalyst 6500 High Switch Proc Philip L. (Nov 17)