nanog mailing list archives

Re: AT&T UVERSE Native IPv6, a HOWTO


From: Owen DeLong <owen () delong com>
Date: Mon, 2 Dec 2013 17:21:03 -0800


On Dec 2, 2013, at 16:57 , Gary Buhrmaster <gary.buhrmaster () gmail com> wrote:

On Mon, Dec 2, 2013 at 11:47 PM, Owen DeLong <owen () delong com> wrote:
....
(Hint, NEST has already released an IPv4 smoke detector).

And they really should have enabled IPv6 on it :-(
But the processor should be able to handle it, if
they update the firmware. I hear Tado does IPv6.

The problem with Tado is that it doesn't do AC, only heat.

I am not so sure about Nest being able to do that with a firmware upgrade.

I haven't looked inside of one, but someone told me that they were using Wiznet chips.

If they are, then that's IPv4 baked into the hardware of the chip and it won't do IPv6. This has been a huge problem 
with trying to do anything IPv6-oriented in the Arduino and other Microcontroller world. The Raspberry PI and the UDOO 
are the first semi-promising solutions that I am aware of in this arean, though the Cubie board and Beagle bone have 
some capabilities here as well... They're just a bit on the pricey side.

Owen



Current thread: