nanog mailing list archives

Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing).

From: James Wininger <jwininger () ifncom net>
Date: Mon, 14 Jan 2013 14:00:06 +0000

All,

We are running into an issue with Brocade where we are finding it difficult to to graph VLAN interfaces for bits 
(in/out) across a tagged (trunk) interface. On Cisco this is not an issue. So what we end up with in Cacti is a blank 
(no data) graph.

I have been all over these devices with snmpwalk etc (typical tool set). Has anyone found a "fix" or work around for 
this? Or perhaps I should be asking a different question….Is there a better tool/mindset for 95% billing since this is 
what we are doing with this info.
--

Jim Wininger

"Don't find fault, find a remedy." - Henry Ford

Current thread:

Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing). James Wininger (Jan 14)
- Re: Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing). Pui Edylie (Jan 14)
- Re: Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing). JP Viljoen (Jan 14)
- Re: Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing). Erik Muller (Jan 14)
  - Re: Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing). Jeroen Wunnink | Atrato IP Networks (Jan 14)
    - Re: Brocade XMR/MLX VLAN bit counters (Cacti graphs for brocade VLANS) (95% billing). Steven Noble (Jan 14)