nanog mailing list archives

Re: Peering issue - Possible Juniper to Cisco issue


From: Michael Loftis <mloftis () wgops com>
Date: Fri, 28 Feb 2014 09:13:59 -0800

On Fri, Feb 28, 2014 at 8:58 AM, Philip Lavine <source_route () yahoo com> wrote:
To all,

I (ASR1001) had an experience recently where the Telco (Juniper) told me that I was sending them 1000+ routes when I 
attempted to re-establish a BGP session; subsequently they would not allow this and they refused the session.

I had no sync on and a prefix list so I was advertising only one route. Even though I hard reset the session on my 
end the Telco for some reason kept seeing me send the routes. I finally called them and had them reset their end and 
the session came up right away.

What the ...

If you leaked once and they have a teardown setup on the Juniper end
w/o a timeout, it won't let the neighbor reconnect until the session
is cleared.  I've seen in IOS 15.x just a few days ago where it had
stuck advertising routes that it shouldn't be, though that was between
two Sup720 based pieces of gear, so probably unrelated (just a data
point that it can/does happen in IOS in general where it's advertising
routes that it insists it isn't)



thx

Philip




-- 

"Genius might be described as a supreme capacity for getting its possessors
into trouble of all kinds."
-- Samuel Butler


Current thread: