nanog mailing list archives
Re: cable modem firmware upgrade
From: Scott Helms <khelms () zcorum com>
Date: Fri, 30 Jan 2015 08:18:39 -0500
Sam, The most common approach from the MSOs is to take one of two paths. Either simply not allow non-approved devices to come online, this is common from the larger MSOs, or to simply not try and update the firmware for unfamiliar devices, this is common for smaller operators. It's very unusual for a MSO to work with an unapproved vendor simply because they almost never have enough of their own customers using those devices to make the effort worthwhile *and *most of the direct to consumer vendors stop producing firmware updates on a much quicker pace than service provider gear vendors do. A direct to consumer device will often get <3 firmware updates total, while the devices sold to/through service providers are supported for much longer and I can commonly get firmware updates for devices that are 8+ years old. Scott Helms Vice President of Technology ZCorum (678) 507-5000 -------------------------------- http://twitter.com/kscotthelms -------------------------------- On Thu, Jan 29, 2015 at 9:56 PM, Sam Hayes Merritt, III <sam () themerritts org
wrote:
That has been my experience as well (only from the RF side) and I wouldbelieve this was a design choice. The ISP usually wants to keep control over the firmware versions of the CM for various technical/support reasons versus having consumers mess with the firmware.Its a design choice but not one that always works out well. Customers that bring their own modems that aren't on a "certified" list, end up with a device that the provider may not have ever seen. Then, if you run into an issue with the modem that can be fixed with a firmware issue (some vendors have issues that they cannot fix - rhymes with netgear) then the MSO has to work with the maker of that modem, even though they may have never had any interactions with them, get the certificate and firmware for that modem and upgrade customer owned devices - possibly turning them into bricks. I'd rather allow customers to turn their own modems into bricks. sam
Current thread:
- cable modem firmware upgrade A MEKKAOUI (Jan 28)
- RE: cable modem firmware upgrade Nathan Anderson (Jan 28)
- RE: cable modem firmware upgrade Frank Bulk (Jan 28)
- RE: cable modem firmware upgrade Paul Stewart (Jan 29)
- RE: cable modem firmware upgrade Sam Hayes Merritt, III (Jan 29)
- Re: cable modem firmware upgrade Scott Helms (Jan 30)
- Re: cable modem firmware upgrade Rob Seastrom (Jan 30)
- RE: cable modem firmware upgrade Paul Stewart (Jan 30)
- RE: cable modem firmware upgrade Nathan Anderson (Jan 28)