nanog mailing list archives
Re: Partial vs Full tables
From: William Herrin <bill () herrin us>
Date: Fri, 5 Jun 2020 10:20:00 -0700
On Fri, Jun 5, 2020 at 9:49 AM Saku Ytti <saku () ytti fi> wrote:
The comparison isn't between full or default, the comparison is between static default or dynamic default. Of course with any default scenario there are more failure modes you cannot route around. But if you need default, you should not want to use dynamic default.
It's a little more nuanced than that. You probably don't want to accept a default from your transit but you may want to pin defaults (or a set of broad routes as I did) to "representative" routes you do accept from your transit. By "pin" I mean tell BGP that 0.0.0.0/0 is reachable by some address inside a representative route you've picked that is NOT the next hop. That way the default goes away if your transit loses the representative route and the default pinned to one of your other transits takes over. You can craft and tune an effective solution here, but there has to be an awful lot of money at stake before the manpower is cheaper than just buying a better router. Regards, Bill Herrin -- William Herrin bill () herrin us https://bill.herrin.us/
Current thread:
- Partial vs Full tables James Breeden (Jun 04)
- Re: Partial vs Full tables Ca By (Jun 04)
- Re: Partial vs Full tables Tore Anderson (Jun 05)
- Re: Partial vs Full tables Saku Ytti (Jun 05)
- Re: Partial vs Full tables Tore Anderson (Jun 05)
- Re: Partial vs Full tables Saku Ytti (Jun 05)
- Re: Partial vs Full tables Tore Anderson (Jun 05)
- Re: Partial vs Full tables Saku Ytti (Jun 05)
- RE: Partial vs Full tables Michael Hare via NANOG (Jun 05)
- Re: Partial vs Full tables Saku Ytti (Jun 05)
- Re: Partial vs Full tables William Herrin (Jun 05)
- Re: Partial vs Full tables Saku Ytti (Jun 05)
- Re: Partial vs Full tables Chuck Anderson (Jun 05)
- Re: Partial vs Full tables Mark Tinka (Jun 09)
- Re: Partial vs Full tables Mark Tinka (Jun 09)
- Re: Partial vs Full tables Job Snijders (Jun 10)
- Re: Partial vs Full tables Mark Tinka (Jun 11)
- Re: Partial vs Full tables Tore Anderson (Jun 05)
- Re: Partial vs Full tables William Herrin (Jun 05)
- Re: Partial vs Full tables Yang Yu (Jun 05)
- Re: Partial vs Full tables William Herrin (Jun 05)