Nmap Development mailing list archives
Re: Can't search thorugh Zenmap
From: David Fifield <david () bamsoftware com>
Date: Thu, 12 Mar 2009 13:07:06 -0600
On Thu, Mar 12, 2009 at 07:19:03AM -0400, Neil Higginbotham wrote:
I keep getting a scan fail when I use the Zenmap interface e.g "Failed nmap -F -S -T4 www.site.com". with a line going through it. Nmap is working fine so its not related to that. I'm wondering if there is any configuration in Zenmap for using the namp api, i just couldn't find anything. Thanks.
Your command line has an error. The -S (source address) option takes an argument, so it interprets -T4 as being a source address. You probably see an error message like Failed to resolve/decode supposed IPv4 source address -T4. Note that if you are using IPv6, the -6 argument must come before -S QUITTING! Provide a source address or remove the -S option and the scan will work. Incidentally, the Zenmap profile editor can help debug command line issues like this. Open the profile editor and type "nmap -F -S -T4 www.site.com" in the Command box. Then on the Source tab, you will see that "-T4" is in the box for -S. Type in a proper source address and the display will fix itself, and -T4 will move over to Scan tab where you intended it. David Fifield _______________________________________________ Sent through the nmap-dev mailing list http://cgi.insecure.org/mailman/listinfo/nmap-dev Archived at http://SecLists.Org
Current thread:
- Can't search thorugh Zenmap Neil Higginbotham (Mar 12)
- Re: Can't search thorugh Zenmap Brandon Enright (Mar 12)
- Re: Can't search thorugh Zenmap David Fifield (Mar 12)
- Message not available
- Re: Can't search thorugh Zenmap David Fifield (Mar 14)
- Message not available
- Message not available
- FW: Can't search through Zenmap Neil Higginbotham (Mar 15)
- Re: FW: Can't search through Zenmap David Fifield (Mar 24)
- Message not available