Re: make install error on nmap 5.21 -- partially solved

[rilian4 rilian4 <rilian4 () gmail com>]

I ran ./configure and make again, this time both as root.(First time was as
normal user and root for the make install) then make install worked fine so
it works that way ok. Not sure why it failed before. Maybe I missed a step
some place between all the stuff I'm bouncing between.

Sorry to have bothered you all,
Aaron

On Fri, Feb 5, 2010 at 2:08 PM, rilian4 rilian4 <rilian4 () gmail com> wrote:

> I downloaded the nmap 5.21 gzip tarball from nmap.org and on my laptop the
> compile/make/make install ran swimmingly. I have a desktop test station
> where I ran through the same steps (Been compiling nmap from source for
> years) and the ./configure and make steps seem fine but make install throws
> this error:
>
>  # make install
> Makefile:341: makefile.dep: No such file or directory
> g++ -MM -Iliblua -Ilibdnet-stripped/include  -Ilibpcap -Inbase
> -Insock/include main.cc nmap.cc targets.cc tcpip.cc nmap_error.cc utils.cc
> idle_scan.cc osscan.cc osscan2.cc output.cc payload.cc scan_engine.cc
> timing.cc charpool.cc services.cc protocols.cc nmap_rpc.cc portlist.cc
> NmapOps.cc TargetGroup.cc Target.cc FingerPrintResults.cc service_scan.cc
> NmapOutputTable.cc MACLookup.cc nmap_tty.cc nmap_dns.cc traceroute.cc
> portreasons.cc nse_main.cc nse_nsock.cc nse_fs.cc nse_nmaplib.cc
> nse_debug.cc nse_pcrelib.cc nse_binlib.cc nse_bit.cc nse_openssl.cc
> nse_ssl_cert.cc  > makefile.dep
> make: *** No rule to make target `liblua/liblua.a', needed by `nmap'.
> Stop.
>
> I tried make clean to no avail. The system runs SuSe and had 5.10beta
> installed from source w/o issue.
>
> Any suggestions?
> Aaron
_______________________________________________
Sent through the nmap-dev mailing list
http://cgi.insecure.org/mailman/listinfo/nmap-dev
Archived at http://seclists.org/nmap-dev/