PaulDotCom mailing list archives
need help with usb cable
From: larry at pauldotcom.com (Larry Pesce)
Date: Fri, 05 Dec 2008 12:42:36 -0500
Yeah, unfortunately, it will affect it. :-( The "stuff" in the middle, is at a minimum a TTL level shifter. Pry that bad boy open and trace the pinout to the chip specs :-) Or pick up an FTDI cable form LadyAda... - L Robin Wood wrote:
2008/12/5 Tim Krabec <tkrabec at gmail.com>:Relatively simple look at the diagram here http://pinouts.ru/Slots/USB_pinout.shtml then use your multimeter to check continuity on the pins to the existing cable and you'll be able to tell which wire goes to which pin, then you're set.I should have added, there is a bit of circuitry in the cable as well that does come conversion - all I know is voltage dropping. Not sure if that will affect it but I'll certainly give it a go. Robin _______________________________________________ Pauldotcom mailing list Pauldotcom at mail.pauldotcom.com http://mail.pauldotcom.com/cgi-bin/mailman/listinfo/pauldotcom Main Web Site: http://pauldotcom.com
Current thread:
- need help with usb cable Robin Wood (Dec 05)
- need help with usb cable Tim Krabec (Dec 05)
- need help with usb cable Robin Wood (Dec 05)
- need help with usb cable Larry Pesce (Dec 05)
- need help with usb cable Tim Krabec (Dec 05)
- need help with usb cable Robin Wood (Dec 05)
- need help with usb cable Tim Krabec (Dec 05)
- need help with usb cable Robin Wood (Dec 05)
- need help with usb cable Robin Wood (Dec 05)
- need help with usb cable Robin Wood (Dec 05)
- need help with usb cable Chris Gerling (Dec 05)
- need help with usb cable Arch Angel (Dec 05)
- need help with usb cable Tim Krabec (Dec 05)