IP name resolution issue

[George Vandelet <george_vandelet () yahoo com>]

Wireshark Superusers,
 
Pardon the second email on this.  I sent the first without a title so it may 
have been dropped by your SPAM filters.
 
Thank you.
 
George




________________________________
From: George Vandelet <george_vandelet () yahoo com>
To: Wireshark Community <wireshark-users () wireshark org>
Sent: Wed, August 11, 2010 3:52:22 PM
Subject: [Wireshark-users] (no subject)


Wireshark Superusers,

I am using the new beta version of wireshark "Version 1.4.0rc2 (SVN Rev 33665 
from /trunk-1.4)" on a windows XP laptop with Service Pack 3.  


I like and have used the feature to manually resolve the IP addresses to a name 
that I determine instead of showing the IP address.  Unforutunately, if I use 
this feature, it does not allow me to change the resolved IP name back to an 
IP.  I have to close the Wireshark application to get back to seeing IPs again.  


Is there a way to change the resolved IP addresses back to unresolved IP 
addresses without having to shut down the Wireshark application? Also, is there 
a trick to just manually resolving a single IP address rather than the entire 
file?

Thanks,

George

PS.  The way that I am resolving the IPs to a host name is as follows

    Have the cursor on the IP address that I wish to resolve.
    right click and select "manually Resolve Adress"
    type in the name that I wish the IP to resolve to
    check the "enable network name resolution"
    and click OK


___________________________________________________________________________
Sent via:    Wireshark-users mailing list <wireshark-users () wireshark org>
Archives:    http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
             mailto:wireshark-users-request () wireshark org?subject=unsubscribe