Re: Problem...

[Bill Meier <wmeier () newsguy com>]

> On 11/17/2013 12:53 PM, Herb Falk <herb () sisconet com> wrote:
> > I just got the SVN stuff to compile, but from the documentation I
> > can't figure out what file is missing and where to put it.
>
> Based upon some preliminary research, it's possible that a setup command will be needed.
>
> I need to do a little further research;
>
> How are you running the newly-built Wireshark ?
>
>   From the wireshark-gtk2 (or whatever is specified as INSTALL_DIR in
> config.nmake) sub-directory in the source tree ?
>
> In any case, please post the output from 'wireshark -v'.


Ok: When building wireshark with GTK3 on Windows in a dev environment, a 
file called gschemas.compiled should be set up under the INSTALL 
directory as share\glib-2.0\schemas\gschemas.compiled
(INSTALL is defined in config.nmake)


From the top-level Makefile.nmake:

...
!IFDEF GTK_SCHEMAS_DIR
        if not exist $(INSTALL_DIR)\$(GTK_SCHEMAS_DIR) ^
           mkdir $(INSTALL_DIR)\$(GTK_SCHEMAS_DIR)
        if not exist $(GTK_DIR)\$(GTK_SCHEMAS_DIR)\gschemas.compiled ^
           $(GTK_DIR)\bin\glib-compile-schemas ^
              $(GTK_DIR)\$(GTK_SCHEMAS_DIR)
        xcopy $(GTK_DIR)\$(GTK_SCHEMAS_DIR)\gschemas.compiled ^
              $(INSTALL_DIR)\$(GTK_SCHEMAS_DIR) /d
!ENDIF
...


(Note that gschemas.compiled is created as needed using
glib-compile-schemas).

I'm not sure why this is not working in your build.

It should have "just worked" ...    :

Is 'C:\wireshark' the directory you've defined as the INSTALL dir in 
config.nmake ??


___________________________________________________________________________
Sent via:    Wireshark-dev mailing list <wireshark-dev () wireshark org>
Archives:    http://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
            mailto:wireshark-dev-request () wireshark org?subject=unsubscribe