Wireshark mailing list archives
Re: Fwd: wireshark file not showing all packets but showing only the first frame..
From: Guy Harris <guy () alum mit edu>
Date: Fri, 19 Feb 2010 12:47:14 -0800
On Feb 19, 2010, at 12:30 PM, prashanth s wrote:
It shows in the pcap at the bottom: Packets: 3481 Displayed: 3481 Marked : 0 But actually only the first frame is displayed.
If this is on a UN*X (Linux, *BSD, Solaris, Mac OS X, etc.), what does the "file" command say when you run it on the pcap file? What happens if you run TShark on it? Does it print all the packets? Is the machine on which it was working OK the same machine as the machine where it isn't working? If so, did you change anything (for example, updating any software, including libraries), in the past couple of days? ___________________________________________________________________________ Sent via: Wireshark-dev mailing list <wireshark-dev () wireshark org> Archives: http://www.wireshark.org/lists/wireshark-dev Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev mailto:wireshark-dev-request () wireshark org?subject=unsubscribe
Current thread:
- wireshark file not showing all packets but showing only the first frame.. prashanth s (Feb 19)
- Fwd: wireshark file not showing all packets but showing only the first frame.. prashanth s (Feb 19)
- Re: Fwd: wireshark file not showing all packets but showing only the first frame.. Guy Harris (Feb 19)
- Re: Fwd: wireshark file not showing all packets but showing only the first frame.. prashanth s (Feb 19)
- Re: Fwd: wireshark file not showing all packets but showing only the first frame.. Abhik Sarkar (Feb 20)
- Re: Fwd: wireshark file not showing all packets but showing only the first frame.. Guy Harris (Feb 19)
- Fwd: wireshark file not showing all packets but showing only the first frame.. prashanth s (Feb 19)